2 Replies Latest reply on May 3, 2017 11:45 PM by randy227

    Configuring transparent bridge interface

    bgamache

      I am currently working on replacing our existing virtual machine Web Gateway 7.3 with 7.6.  Installing the VM is not an issue.  I am configuring up the new VM the same as the old VM.  I configured two interfaces to use the bridge and a third for management.  Again, this was the previous configuration.  After setting up the ibr0 interface, I restart the appliance to get the bridge interface up.  Unfortunately, I receive the attached error where interface eth0 will not install it itself in the bridge.  I've attempted to troubleshoot this in many ways but unable to get the bridge interface up.  Anyone have any ideas as to why eth0 will not participate in the bridge?