I have two different machines. one for standalone and one for epo.
So i am looking for both
Great, So for the Standalone installer you need to log into the McAfee Downloads page and log in with your Grant Number and download the Standalone installer from the 'Software downloads' tab:
For ePO, you can either pull the Threat Prevention package in via the Software Manager or you can download the package from the same downloads page above but navigate to the 'Packages' tab and check the package (and extensions) into ePO:
Once the ePO package is in your Master Repository you can deploy the software using the Agent Product Deployment task.
Thank you rich it was in need a fast response.
I am new to this setup function
i am a bit confused Rich. on standalone and epo. Can u explain in brief? It will be of great help.
Sure, what do you need to know?
How to run the installer or how to configure ePO?
I would be troubling you with 3 queries:
1 Difference between installer and epo
2 I have a request for manually "
how to install and uninstall McAfee End Point Protection for Mac
(This is called Endpoint Security Threat prevention)"
3 How do i do it?
I am confused with all the stuff i searched from knowledge base since morning.
The product guide is available here:
Stand alone installation is covered off from page 15 and ePO managed installs are covered from page 45.
These instructions should be able to walk you through both processes.
Thanks Rich. I will go through it. And in case of any queries i will reach you back.
Hope you will be in a state to respond