3 Replies Latest reply on Apr 11, 2016 1:48 PM by techynewbie

    ESM 9.5 Installed on VM - how to configure ESM to listen on other interfaces (eth1)

    techynewbie

      I installed ESM 9.5 on VMWare and have 2 interfaces attached:

       

      eth0: ESM recognizes as console

      eth1: would like ESM to listen on this interface but cannot figure out in console UI how to activate this

       

      The reason is that I am evaluating ESM and would like eth1 to be connected on a virtual switch to simulate suspicious traffic.

       

      Any info would be helpful.

       

      thank you!