1 2 Previous Next 10 Replies Latest reply on Jan 25, 2016 2:03 PM by penoffd

    Receiver doesn't get new events

    dzh01

      I updated our ESM to 9.5.1 MR2 on 12/22 and since 12/23 one of our Receivers is totally dead without and new events. If I SSH into it and perform NitroStop --nod and then do a NitroStart --nod it will begin to receive new events temporarily before going silent again. I've contacted support but they haven't been very helpful and insist the issue is my service account I'm using for WMI pulls. If I go into the data source and perform connect it does say it connects successfully.

        1 2 Previous Next