2 Replies Latest reply on Dec 20, 2015 1:50 PM by twisted_pony

    Changing GUI port for admin access back to 4712

    twisted_pony

      Hi all,

      Is there a method of changing the https connector port back to 4712, from the command line?

      (the port has been changed and promptly forgotten, and we have no access to the gui via 4711 and we never will have).

      We do have ssh and local access to the appliance....

      The appliance is part of a central management group of two mwg' some..

       

      We also have a valid backup which we could restore to the appliance (restore configuration as well as policy), which I think will restore the listener to 4712, but it's a last resort.

       

      Any thoughts appreciated...

        • 1. Re: Changing GUI port for admin access back to 4712

          Look at the file:

          /etc/mwg-ui/server.xml

           

          Look for the lines with the port number defined:

          <Connector server="mwg-ui" URIEncoding="UTF-8" port="NNN" protocol="HTTP/1.1" maxThreads="500" connectionTimeout="20000" redirectPort="8443" maxPostSize="2048" maxSavePostSize="0" />

          <Connector server="mwg-ui" URIEncoding="UTF-8" port="NNN" protocol="HTTP/1.1" SSLEnabled="true" maxThreads="500" connectionTimeout="20000" scheme="https" secure="true" SSLProtocol="TLSv1+TLSv1.1+TLSv1.2" SSLCipherSuite="!ADH:!aNULL:!eNULL:!3DES:HIGH" SSLHonorCipherOrder="true" SSLCertificateFile="/usr/share/mwg-ui/ssl/servercert.pem" SSLCertificateKeyFile="/usr/share/mwg-ui/ssl/serverkey.pem" maxPostSize="2048" maxSavePostSize="0" />

           

          Those should be the ones you can access.

          If you want to temporarily change them, edit the numbers and service mwg-ui restart

          Once you are back in the GUI, change it and save it so it's permanent again.