1 Reply Latest reply on Nov 3, 2015 3:02 AM by ninjaneer68

    configure ePO to use commonupdater

    ninjaneer68

      I have found the below KB Article for the links to the commonUpdater. I can't find instructions on how to configure the ePO to use it. Any have any good links or KBs of how to set up the ePO to use the CommonUpdater ? My ePO verison is 4.6.X

      I take it the ePO just updates content from the common updater, that the products them self are updated separately ?

       

       

      McAfee KnowledgeBase - CommonUpdater download sites

       

       

      After posting, I found in server settings

       

      server settings > source sites

      If I put in Mcafee FTP it works

      if I put in mcafee source - update.nai.com/Products/CommonUpdater - fallback - enabled. When pulling from task it fails

       

      Summary,

       

      I am assuming just update source sites, then create a server task to pull from the source site and pick if it goes to current, or evaluation

        • 1. Re: configure ePO to use commonupdater
          ninjaneer68

          Not sure why but when its trying to update the engine it fails

           

          McAfeeHttp

          11/3/15 5:02:00 PM

          INFO

           

          Downloading package Current\VSCANENG1000\5700.7163\Engine\0000

           

          McAfeeHttp

          11/3/15 5:02:00 PM

          INFO

           

          Checking in package Current\VSCANENG1000\5700.7163\Engine\0000

           

          McAfeeHttp

          11/3/15 5:02:01 PM

          ERROR

           

          Failed to check in package Current\VSCANENG1000\5700.7163\Engine\0000