ePolicy Orchestrator (ePO)
Please enter a title.
You can not post a blank message. Please type your message and try again.
This discussion is archived
on Dec 11, 2007 11:30 AM by boohbah
Rogue System Detection - Subnet Condition
Dec 11, 2007 3:55 AM
I am trying to set Rogue System Detection to stop scanning our RAS / VPN range. (10.137.x.x)
I've had a look in the settings and think i need to add a condition but i'm getting confused.
Within Repsonses, Add Condition, IP Range.
Do i need to select 'is in range' or 'is not in range'? What IP addresses do i put into the value fields? 10.137.???.???
Any help would be great! :)
This content has been marked as final.
Show 1 reply
RE: Rogue System Detection - Subnet Condition
Dec 11, 2007 11:30 AM
in response to PBateman
where you are looking, is the responses of what to do when a host within a given subnet is detected..
i think what you want to do is stop the detection at source, ie, the sensor.
within the RSD sensor policy you have the option to control what networks are, and are not included for detection - it governs what virtual nics the sensor will bind to
i think this is what you are looking for
Remove from profile
Feature on your profile
More Like This
Retrieving data ...