0 Replies Latest reply on Jun 23, 2015 1:36 PM by docdriza

    IPS Sensor Factory defaults

    docdriza

      I don't know where else to put this. I have an old I-1400 that I am trying to set back to the defaults. I have a serial cable connected to this but cannot figure out what the settings need to be in order to successfully connect to it. I tried to use the setting shown in the quick start guide of M-1450 and that did not work. I tried to use the settings in the link below, and that did not work. What am I doing wrong?

       

      https://kc.mcafee.com/corporate/index?page=content&id=KB56426

       

      Thanks.