5 Replies Latest reply on Mar 10, 2015 7:34 AM by M Bagheryan M

    WebGateway config

    acrux

      I have a customer who has a WG-4000b in place but it doesn't seem to be working in the sense of any policy working. It has to be passing traffic through the device as it sits inline between the switches and firewall.

       

      I know little about this device but here is the current setup.

       

      Port 1 on MWG (eth0) - IPv4 Disabled and in Bridge Mode to ibr0

      Port 2 on MWG (eth1) - IPv4 Disabled and in Bridge Mode to ibr0

      Port 3 on MWG (eth2) - IPv4 enabled with IP/Subnet

      ibr0 - IPv4 enabled with IP/Subnet

       

       

      visio.topology.PNG

       

      There is only a few policies setup, but all are 'enabled' when clicking on them to edit. When I look at reporting though nothing outside of the device performance is being captured.

       

      Any help would be greatly appreciated.