I was hoping to get some assistance with this task. When I do a Run Client Task Now from the ePO console and run a task, the timeout value defaults to 20 minutes. This is located on the second tab, Options, second from the bottom under "Stop Task on the Client After:" The timeout value can be changed, but for some reason defaults to 20 minutes. I would like to change this default but i haven't been able to find a location to do so. I have found this 20 minute default to be especially troublesome when doing on-demand scans. In some cases, I remember to manually increase it, but quite often I don't and then I have to wait the 20 minutes for the task to timeout before I can run it again (it cannot be manually terminated). Any assistance would be appreciated.