Sorry, the wording isnt very clear. Could you clarify further if this is a ruleset or a single rule?
If it was a ruleset, you cannot apply an action. You can only apply an action in the rules within the ruleset.
-Continue = Continue processing rules
-Block = Stop everything and block the request/response/embedded
-Stop Ruleset = Stop processing the rules in the given ruleset
-Stop Cycle = Stop processing all rules in the given cycle (request/response/embedded)
JonFollow Up Tomorrow -- ABENJAMI
I made a top level rule that does nothing, and within that have 3 rules that do an action base on your IP.
So If the first one matches what is the action to stop processing the other 2 rules? but if it does not match, It should continue checking the next rule....
not sure of the terminology of rule set, hope this helps.
in case the three rules are within one single rule set "Stop Rule Set" is the right action. The first matching rule will be executed, all others won't do anything. If one rule with "Stop Rule Set" matched, the remaining rules within this rule set are skipped.
Please note that "Stop Rule Set" will stop the processing of further rules within the rule set where you have called it + all child rule sets.