1 Reply Latest reply on May 29, 2013 8:35 AM by northomsk

    Tasks set in EPO for Application Control

    northomsk

      Dear all

       

      A question about tasks set in EPO for Application Control.

      Lets say i have SC: Enable Application Control, full feature, start Observe mode

      If i then like to end observe mode -> will leave the task but just disable it and create a new under SC: Observe Mode, End observe mode and Enable ticked

      Then if i look in the task folder on the client i will see SC: enable application control set to Enable=0 and SC: Observe mode set to Enable=1

      But this will leave the machine in Observe mode

      Not until i delete the SC: Enable Application control and then i will have McAfee Solidifier as Enabled

       

      Is the above by default

       

      Cant you have tasks sitting in the task folder that are set to Enable=0 (and they will not have any impact on the client machine)? will be igmored and system will look on tasks set to Enable=1

       

      Regards