1 Reply Latest reply on Aug 3, 2012 5:28 AM by Tristan

    Cannot connect NSP Sensor M-2850

    prasunthapa

      I am unable to connect to sensor through Serial console.

      Receiving following error

      Error: Unable to locate a working CMD and/or SLV_CMD strobe configuration for th                                                                             Type esc key to enter board setup

      ----- Configuring DRAM Channel 0 -----

       

       

      Type esc key to enter board setup CMD and/or SLV_CMD strobe configuration for this channel.

      ----- Configuring DRAM Channel 0 -----

        • 1. Re: Cannot connect NSP Sensor M-2850
          Tristan

          Is the unit operational or is the error displayed during a power up.

           

          A quick browse on Google would suggest that this is a low level hardware failure message being redirected to stdout and therefore appearing on the console.

           

          I don't think there's much you can do but raise a ticket with McAfee support.