2 Replies Latest reply on Jul 26, 2012 4:20 AM by hbajaj

    Need rules for few incidents

      I need Error handler rules/rule-sets for below incidents:

       

      20

      21

      22

      902

      903

      932

      933

      301

      3000

      3001

      3005

       

      I want to enable SNMP trap notification when these incidents occur. I have already enabled the exisitng/default error handler rule-sets, but need few more.

       

      - heena

        • 1. Re: Need rules for few incidents
          Jon Scholten

          Hi Heena,

           

          This is very easy to do. There is already rulesets which demonstrate what is necessary.

           

          For demonstration purposes, you can use this attached ruleset, it is a catch all. I have built in rules for ignoring certain Incidents or Errors. As for Incidents, a severity is set for every incident, so in my ruleset it will only allow incidents with a severify 5 or higher (1 being the highest).

           

          This could easily be reconfigured to send traps for specific incidents.

           

          Placement of this ruleset is very important. You can place it at the top for testing.

           

          catchall.png snmpincident.png

           

          Hope this helps!

          -Jon

           

          Message was edited by: jscholte (spelling) on 7/25/12 12:21:16 PM CDT
          • 2. Re: Need rules for few incidents

            Awsome. This covers all incidents. Thanks.