0 Replies Latest reply on Apr 9, 2012 2:18 PM by chisro

    Webgateway Central Management Configuration

      I would like to set up central management on webgateway 7.1.0.6 that only updates policies and engine updates on my 2 new appliances.

      I dont want to have any network bandwidth sharing because the second appliance is just a disaster recovery  appliance.

      Should I just enable group runtime and group update and clear the group network "all" ?

      Thanks

      Rob

       

       

      thank you support!

      on the first appliance(example ip 1.2.3.4)

      go to configuration-->central managemant config

      add the ip address of the appliance that you are on in the top box

      click add

      add the ip and port as follows 1.2.3.4:12346<---this is the default port number and is required

      save changes

       

      go to the second appliance

      on the second appliance(example ip 2.3.4.5)

      go to configuration-->central managemant config

      add the ip address of the appliance that you are on in the top box

      click add

      add the ip and port as follows 2.3.4.5:12346<---this is the default port number and is required

      save changes

      logout of the second appliance

       

      go to the first appliance

      configuration-->click on appliances(cluster) at the top

      click add

      add the second appliance ip 2.3.4.5

      click ok.

      you are done.

      thank you support

      now why couldnt you put that in the product guide like that?????

       

      Message was edited by: chisro on 4/9/12 2:18:04 PM CDT