4 Replies Latest reply on Nov 27, 2007 9:39 AM by kjhurni

    Adding Patch4 for 8.5i into the MID causes setupvse.exe to fail

    kjhurni
      If I add in Patch4.msp to the MID for 8.5i, it generates an install for me. However, when I run setupvse.exe it then immediately crashes and fails and wants to send an error report to MS.

      If I take the setup.ini file and remove the line:

      PatchFile0=PATCH4.MSP

      Then it works fine (but of course, it doesn't apply the patch)

      Is this a problem with Patch4, or 8.5i, or the MID?

      I've reproduced this consistently (I tried 5 times last night with fresh downloads each time in case I was doing something wrong).