Did you set the IP during installation in the wizard? What displays on the output of the following commands?
ip route show
If no to the answers above you need to set the IP by performing the following:
ifconfig eth0 IP/NETMASK
ip route add default via DEFAULT-GW-IP
thanks for your response..
i entered the commands which you asking about and these are the snapshots of the displayed data..
i followed the installation wizard while installing the VM and gave it an ip 10.0.0.162 with 255.255.255.0 , and GW 10.0.0.138..
regards to network configuration, i tried both bridge and NAT..
I'd used the previous version 6.x as a demo VM on the same machine before and it was working well.
give me any ideas about this issue, please.
Do the network paramters you have choosen match the VMWare settings for virtual networks?
it's not clear to me,, can you clarify please.