1 Reply Latest reply on Mar 12, 2010 8:59 AM by JoeBidgood

    ePO 4.0 Uncovered subnets

      I was wondering how I can configure rogue sensors that are located in subnet A also look in subnet B. We are working with VLANs and servers ( one per VLAN ) are upgraded to rogue sensors. But in some VLANs there are only clients, but also not covered? How to do this?

       

      TIA

        • 1. Re: ePO 4.0 Uncovered subnets
          JoeBidgood

          You can configure which interface(s) the sensors listen on in the RSD sensor policy, but as long as subnet A can see subnet B, then there should be no problem. If there' s no routing between subnets though then you will need to put a sensor in each one.

           

          Regards -

           

          Joe