cancel
Showing results for 
Search instead for 
Did you mean: 
CKZ
Level 7
Report Inappropriate Content
Message 1 of 2

ePO 4.0 Uncovered subnets

Jump to solution

I was wondering how I can configure rogue sensors that are located in subnet A also look in subnet B. We are working with VLANs and servers ( one per VLAN ) are upgraded to rogue sensors. But in some VLANs there are only clients, but also not covered? How to do this?

TIA

1 Solution

Accepted Solutions
McAfee Employee JoeBidgood
McAfee Employee
Report Inappropriate Content
Message 2 of 2

Re: ePO 4.0 Uncovered subnets

Jump to solution

You can configure which interface(s) the sensors listen on in the RSD sensor policy, but as long as subnet A can see subnet B, then there should be no problem. If there' s no routing between subnets though then you will need to put a sensor in each one.

Regards -

Joe

1 Reply
McAfee Employee JoeBidgood
McAfee Employee
Report Inappropriate Content
Message 2 of 2

Re: ePO 4.0 Uncovered subnets

Jump to solution

You can configure which interface(s) the sensors listen on in the RSD sensor policy, but as long as subnet A can see subnet B, then there should be no problem. If there' s no routing between subnets though then you will need to put a sensor in each one.

Regards -

Joe

More McAfee Tools to Help You

Community Help Hub

    New to the forums or need help finding your way around the forums? There's a whole hub of community resources to help you.

  • Find Forum FAQs
  • Learn How to Earn Badges
  • Ask for Help
Go to Community Help

Join the Community

    Thousands of customers use the McAfee Community for peer-to-peer and expert product support. Enjoy these benefits with a free membership:

  • Get helpful solutions from McAfee experts.
  • Stay connected to product conversations that matter to you.
  • Participate in product groups led by McAfee employees.
Join the Community
Join the Community