I have setup RSD on ePO and on clients for each subnet. In my ePO it shows all L3 interfaces from Cisco L3 switch as printers. I expect this to display it as unknow or Cisco device. How can I fine tune this settings and reporting?
Have you updated the Detected System OUIs: The OUI (Organizational Unique Identifier) is used to identify the vendor, manufacturer or other organization of a particular piece of equipment. ePO uses this to identify the vendor of a specific network interface controller (NIC) whether physical or virtual. This information is maintained by the IEEE Registration Authority. (Server Settings / Detected System OUIs)
Following list is available, which list should I import in ePO?
IEEE MA-L Assignments (.csv)
IEEE MA-M Assignments( .csv)
IEEE MA-S Assignments (.csv)
IEEE IAB Assignments (.csv)
IEEE CID Assignments (.csv)
IEEE Ethertype Assignments (.csv)
IEEE Manufacturer ID Assignments (.csv)
IEEE Operator ID Assignments (.csv
You may consider going to ePO / Configuration Server Settings / Detected System OUIs / Edit / Update
Was my reply helpful?
If this information was helpful in any way or answered your question, will you please select Accept as Solution in my reply and together we can help other members?