cancel
Showing results for 
Search instead for 
Did you mean: 

EPO configuration of "VSE for Storage"

Jump to solution

Hello,

we are using EPO 4.5 with VSE 8.7, HIPS 7.0, Agent 4.5  and VSE for Storage. The module "VSE for Storage V1.0.0  Build 219" is checked in in master repository. An installer task is also configured for  "VSE for Storage" and was installed on the appropriate machines.

How can we configure the settings (exclusions ...) for this module? We can see in ploicies tab only the extensions of VSE, HIPS and Agent. Is there a special extension for "VSE for Storage" needed to configure the settings?

Thanks and regards

Janni

1 Solution

Accepted Solutions

Re: EPO configuration of "VSE for Storage"

Jump to solution

Inside the main software zip file is another file called VSESTOMD1020.zip. Extract VSESTOMD1020.zip to a folder on the hard drive and check it in as an extension. You should then see what your looking for in ePO.

5 Replies
hemantk
Level 12
Report Inappropriate Content
Message 2 of 6

Re: EPO configuration of "VSE for Storage"

Jump to solution

Hello

You must see the setting for VSE storage under VSE Policies under category

Re: EPO configuration of "VSE for Storage"

Jump to solution

Hello,

thanks for your fast answer. Which of the 11 VSE categories are for "VSE for Storage"?

I have installed the "normal" VSE 8.7 and the "VSE for Storage" on the appropriate machine using two installer tasks. And the VSE 8.7 is visible on the task bar of the machine. Is there one (VSE) setting configuration for VSE and for "VSE for Storage"? Is the VSE 8.7 module needless on this machine if I use "VSE for Storage"?

Regards Janni

hemantk
Level 12
Report Inappropriate Content
Message 4 of 6

Re: EPO configuration of "VSE for Storage"

Jump to solution

Hello

You can get VSE storage setting in VSE console(Open VSE 8.7 console & you can see 1 task got added under Task.)

Re: EPO configuration of "VSE for Storage"

Jump to solution

Hello,

yes you are right. On the local VSE console I can configure  the "Network Appliance Filer AV Scanner". But is there any possibility to configure this setting centalized in the EPO environment like the "normal" VSE settings?

Regards Janni

Re: EPO configuration of "VSE for Storage"

Jump to solution

Inside the main software zip file is another file called VSESTOMD1020.zip. Extract VSESTOMD1020.zip to a folder on the hard drive and check it in as an extension. You should then see what your looking for in ePO.