Currently in my environment, I have client task to start a scheduled scan by every Wednesday 2:00AM (non business hours). though the over all compliance percentage per day is more than 90%, I could see that most of the machines are not getting scan task and scan completed.
I would like o know a suggestion on "Missed task option" or any other client task option in ePO to make all the desktops getting scan initiated and completed.
We use the 'Missed Task' option for this very reason. We schedule our Front of office scans for a time where we know they will be switched off, and using the Missed Task option with a delay of 30 mins to enable the user to 'start' the machine.
McAfee Volunteer Moderator
Thanks Rich 🙂 So how does MISSED TASK with 30 min delay works ?
Below is my understanding. let me know if it is correct or wrong ?
Will this configuration increases CPU utilization of the machine as the scan is initiated immediately after the login. ??
The Client Task assignment will have no effect on the task CPU utilisation weather it runs at 02:00 or 10:30. The Client task will use the same amount of resources. So yes your assumption that the CPU utilisation will increase is correct.
Our DAT update task is set as follows:
This has the effect that the task will run 30 mins after the service detects that the task was not run at the prescribed time, ie in this instance 30 mins post boot/service start.
We normally run our Front Office scans during the nominal Lunch break, so the last kicks off at 13:00. Our business accepts that we need to scan all the machines but we try to make it as least inconvenient as possible to the end users.
Hi , as Richard explained,
using the specific task option is a good way to plan your tasks in detail. If you activate this features and you want to figure out some more info what happens like... scan was cancelled or something else you may check the Event Filter.
There are specical events that can be activated (not shure if they are activated per default) to track if an OnDemand Scan was executed.
Event 1034: Scan completed. No viruses found. (Info)
Event 1035: Scan was cancelled. (Info)
Event 1202: On-Demand Scan started (Info)
Event 1203: On-Demand Scan complete (Info)
In some special cases there are to many endpoint tasks at the same time and some tasks therefore are not started. Also check your Task Assignments. You can also use the Performance Optimizer Extension to check such troubles.
An Reporting hint, use the "last communication" value to see if the systems are online. Often systems are not online and this has an effect for you reports.