EPO Installation can't connect on port

[User50602331]

Hi. I am running into issues trying to get the EPO install to get past the initial SQL communication. I am installing on a hyperV Win2019 server with SQL2019 installed. Setup was unable to access the sql udp port 1434 on the specified sql server..... TCPIP is enabled and I entered the generic 1433 sql as the port to use. Same result. Firewall is turned off and the port is not being blocked. Advice? Thanks in advance. Brad

[aguevara]

could you try this article?

https://kc.mcafee.com/corporate/index?page=content&id=KB88000

If those settings are OK, can you do test UDL from the ePO server and see if that work from the ePO server pointing to the SQL DB?

https://kc.mcafee.com/corporate/index?page=content&id=KB70929

Regards

Alejandro

Was my reply helpful?
If this information was helpful in any way or answered your question, will you please select Accept as Solution in my reply and together we can help other members?

[cdinet]

1434 port is typically the sql browser port - is sql browser service running?  Also, did you confirm all the cipher/tls requirements are met on both epo and sql servers - see KB91519.  The easiest way to confirm that is to download IISCrypto, run it on both servers, choose best practices and then reboot.

[cdinet]

I also missed where epo is on same server - for install purposes only when epo is on the same server, we also need tls 1.0 enabled (just during the install)..