cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
mgarten
Level 7
Report Inappropriate Content
Message 1 of 1

Deep Command 2 - Client task execution - Run the following Command afterwards

Hello,

I started to use Deep Command. I want to use the client task execution part.

Especially the part "Run the following command afterwards". I would like to start a batch file located on the client system with this option but I do not have success. It doesn't shutdone the system

(see also "McAfee ePO Deep Command 2.0.0" product Guide page 117, "How can I implement multiple arbitrary ...)

From the log file "amtct_out.log" on the client I have this log lines:

20-02-2014 13-28-55.jpg
So I assume the problem is within the batch file. Here my simple batch file. When it works I would like to add mor commands:

20-02-2014 13-30-54.jpg

OK, so far. Question is: where is the problem?

Thanks for your attention.

bye

mgarten

Message was edited by: mgarten on 20/02/14 13:39:05 CET

Message was edited by: mgarten on 20/02/14 13:39:52 CET
You Deserve an Award
Don't forget, when your helpful posts earn a kudos or get accepted as a solution you can unlock perks and badges. Those aren't the only badges, either. How many can you collect? Click here to learn more.

Community Help Hub

    New to the forums or need help finding your way around the forums? There's a whole hub of community resources to help you.

  • Find Forum FAQs
  • Learn How to Earn Badges
  • Ask for Help
Go to Community Help

Join the Community

    Thousands of customers use the McAfee Community for peer-to-peer and expert product support. Enjoy these benefits with a free membership:

  • Get helpful solutions from McAfee experts.
  • Stay connected to product conversations that matter to you.
  • Participate in product groups led by McAfee employees.
Join the Community
Join the Community