Create an access test blockpage

[Fxta]

Hello,

I tested recently Cisco Umbrella.

It has a nice feature where you can specify a source IP/Username and an URL, then Umbrella will show you if the result will be OK or KO and all the rules that match.

I would like to make a simple blockpage where I can fill source IP/username + Url, then the webgateway will answer me if the traffic will pass and all the rules that match (Continue, stop rule set, stop cycle, block).

But I have no idea how to do that or where I can find some html/javascript to source to modify.

Do you know if it is possible ?

Best regards,

FX

[aloksard]

Hi,

Hope you are doing well.

https://community.mcafee.com/t5/Documents/Web-Gateway-mwginternal-com-Get-Creative-with-your-Rules/t...

In our default rule set library-> Troubleshooting-> Check URL named rule set is present.You can take a look at Check URL' rule set in the rule set library under the Troubleshooting section.

Let me know if above info is useful an is what you are looking for?

Regards

Alok Sarda

[Fxta]

Hello,

Thank you for you reply.

It's a good start but it will not check my rules.

For example, with the check url block page, If I set www.google.com, it will answer that the category is search engine.

But Maybe I set for a specific scope that the search engine are block.

An example on Umbrella:

https://docs.umbrella.com/deployment-umbrella/docs/umbrella-policy-tester-1

Best regards,

FX