cancel
Showing results for 
Search instead for 
Did you mean: 
ittech
Level 13

Connect MWG 7.4 to ePO 5.1

Jump to solution

I'm having an issue connecting my ePO (5.1) to the MWG7 (7.4.2 transparent setup). I have the Bypass rule and account set up on the MWG7, I have extension 7.4.0.54 installed on the ePO.

Is there a place I can verify that the default ports (7412 and 9090) are the ports that my MWG7 are using? Is there something else that might be missing?

Thanks

0 Kudos
1 Solution

Accepted Solutions
McAfee Employee

Re: Connect MWG 7.4 to ePO 5.1

Jump to solution

Hi Ittech,

Apart of the ePO integration is the "Common catalog". This means that you must do the following:

1. Create user accounts under two places (for starters, use the same username and password):

  • Configuration > ePolicy Orchestrator
  • Accounts, this account must be associated with the Common Catalog Administrator role

2. Make sure you have the Bypass ePO requests ruleset at the top of the ruleset (which you mentioned you do)

3. Enable REST for port 4712 under Configuration > User Interface

4. In ePO when you are setting it up, use the accounts you created in step 1.

Best Regards,

Jon

4 Replies
akill
Level 9

Re: Connect MWG 7.4 to ePO 5.1

Jump to solution

Under configuration>User Interface you can confirm the 4712 port or the port that you has configured and under Configuration>Proxy is where you can confirm the proxy port(by default 9090)

ittech
Level 13

Re: Connect MWG 7.4 to ePO 5.1

Jump to solution

Well, I think I have it set up then.

mwg1.PNG

mwg2.PNG

But when I try to register the gateway in ePO it still doesn't connect. I get a certificate error.

0 Kudos
McAfee Employee

Re: Connect MWG 7.4 to ePO 5.1

Jump to solution

Hi Ittech,

Apart of the ePO integration is the "Common catalog". This means that you must do the following:

1. Create user accounts under two places (for starters, use the same username and password):

  • Configuration > ePolicy Orchestrator
  • Accounts, this account must be associated with the Common Catalog Administrator role

2. Make sure you have the Bypass ePO requests ruleset at the top of the ruleset (which you mentioned you do)

3. Enable REST for port 4712 under Configuration > User Interface

4. In ePO when you are setting it up, use the accounts you created in step 1.

Best Regards,

Jon

ittech
Level 13

Re: Connect MWG 7.4 to ePO 5.1

Jump to solution

Jon Scholten wrote:



3. Enable REST for port 4712 under Configuration > User Interface


It was that right there! Thanks, Jon, you saved me again

Sorry it took a bit, I was on vacation.

0 Kudos