cancel
Showing results for 
Search instead for 
Did you mean: 
erichk
Level 7

Authentication.UserGroups

Jump to solution

I'm trying to trigger an allow action based on an AD security group. I've setup the error page to show the Authentication.UserGroups and only see the first 31 groups. If I trigger the rule on one of the 31 groups shown on the error page it works as expected. The problem is that the group I need to use is beyond those that are shown. I've tested by increasing the max http header up to 45 MB in 5 MB increments and still only see 31 groups with each test.

What could I be missing?

Thanks!

0 Kudos
1 Solution

Accepted Solutions
McAfee Employee

Re: Authentication.UserGroups

Jump to solution

Try checking the box for "Get local groups" perhaps this is where the groups you are looking for can be found.

This can be found in your NTLM authentication settings.

~Jon

0 Kudos
1 Reply
McAfee Employee

Re: Authentication.UserGroups

Jump to solution

Try checking the box for "Get local groups" perhaps this is where the groups you are looking for can be found.

This can be found in your NTLM authentication settings.

~Jon

0 Kudos