cancel
Showing results for 
Search instead for 
Did you mean: 
ivio
Level 7

Integrate MVM 7.0.3 with Active Directory

Jump to solution

Hello All,

i want to integrate MVM 7.0.3 with active directory to discover asset but have a found error and asset not appears,

here is capture my datasource configuration (develpoment)

Image001.jpg

Image002.jpg

browse computer

Image003.jpg

please advise...

thank you

0 Kudos
1 Solution

Accepted Solutions
spayne
Level 8

Re: Integrate MVM 7.0.3 with Active Directory

Jump to solution

Under LDAP Attribute Mapping, clear the fields out on the right side.  You need to enter the names of LDAP Attributes there.  For NetBIOS Name: just put the word "name" without quotes.   For DNS Name: put "dnshostname".  Leave the domain name , ip address, and mac address fields blank.

You could try different LDAP search filters.  Try leaving it blank or removing the () around your filter.

Message was edited by: spayne on 8/2/11 3:38:21 PM CDT
0 Kudos
2 Replies
spayne
Level 8

Re: Integrate MVM 7.0.3 with Active Directory

Jump to solution

Under LDAP Attribute Mapping, clear the fields out on the right side.  You need to enter the names of LDAP Attributes there.  For NetBIOS Name: just put the word "name" without quotes.   For DNS Name: put "dnshostname".  Leave the domain name , ip address, and mac address fields blank.

You could try different LDAP search filters.  Try leaving it blank or removing the () around your filter.

Message was edited by: spayne on 8/2/11 3:38:21 PM CDT
0 Kudos
ivio
Level 7

Re: Integrate MVM 7.0.3 with Active Directory

Jump to solution

Hi Spayne,

Actually i have crashed with my vm that run MVM 7.0 so i will build again and try your solution, i will update to you if i have done build my environment...

thanks,

0 Kudos