Hi Heroes,
We are planing to migrate our ePO server to another machines with the same ip/fqdn, the DB server remains unchanged.
Just to double confirm - does our TIE/DXL Broker server needs any additional configuration after the ePO migration is done?
Thanks in advance.
Solved! Go to Solution.
Hello User21257322,
Ideally the agent will just start checking into the new ePO server. However, in the case this does not work, due to certs being different, etc there is a command you can run on the TIE servers themselves 'reconfig-ma'. This will reprovision the agent with the "new" ePO server.
If the agent does just start checking into the new ePO installation, there is still a good chance the ePO certs will change during the migration. So I would recommend running this command on each TIE server after the migration: reconfig-cert.
This will ensure the servers are operating with certs from the same CA as your ePO server. It may prevent some issues down the road.
Thanks
Brian
Hello User21257322,
Ideally the agent will just start checking into the new ePO server. However, in the case this does not work, due to certs being different, etc there is a command you can run on the TIE servers themselves 'reconfig-ma'. This will reprovision the agent with the "new" ePO server.
If the agent does just start checking into the new ePO installation, there is still a good chance the ePO certs will change during the migration. So I would recommend running this command on each TIE server after the migration: reconfig-cert.
This will ensure the servers are operating with certs from the same CA as your ePO server. It may prevent some issues down the road.
Thanks
Brian
Corporate Headquarters
6220 America Center Drive
San Jose, CA 95002 USA