cancel
Showing results for 
Search instead for 
Did you mean: 
amathu
Level 7
Report Inappropriate Content
Message 1 of 3

ETM-5700 Combo Box - Addition of ELM and ERC

Jump to solution

Hello Guys,

 

We recently aquired a 5700 ETM Combo Box. We re imaged the box with McAfee ESM 10.2.3 and have been able to connect and reach it over the network. When we tried to add the ELM and ERC we faced a challenge. The addition requires input of an IP address, which in this case is the ESM IP itslef since its a combination box.

How do we add the ERC and ELM to the box itself?

1 Solution

Accepted Solutions
Reliable Contributor akerr
Reliable Contributor
Report Inappropriate Content
Message 2 of 3

Re: ETM-5700 Combo Box - Addition of ELM and ERC

Jump to solution

It sounds to me like you used the wrong image on the box.

2 Replies
Reliable Contributor akerr
Reliable Contributor
Report Inappropriate Content
Message 2 of 3

Re: ETM-5700 Combo Box - Addition of ELM and ERC

Jump to solution

It sounds to me like you used the wrong image on the box.

Highlighted
amathu
Level 7
Report Inappropriate Content
Message 3 of 3

Re: ETM-5700 Combo Box - Addition of ELM and ERC

Jump to solution

Thanks for the reply. It was caused by a wrong image. We have since rectified and used only the ESM image.

More McAfee Tools to Help You
  • How-to: Endpoint Removal Tool
  • Support: Endpoint Security
  • Visit: Business Service Portal
  • More: Search Knowledge Articles
  • ePolicy Orchestrator Support

    • Download the new ePolicy Orchestrator (ePO) Support Center Extension which simplifies ePO management and provides support resources directly in the console. Learn more about ePO Support Center