Hello Guys,
We recently aquired a 5700 ETM Combo Box. We re imaged the box with McAfee ESM 10.2.3 and have been able to connect and reach it over the network. When we tried to add the ELM and ERC we faced a challenge. The addition requires input of an IP address, which in this case is the ESM IP itslef since its a combination box.
How do we add the ERC and ELM to the box itself?
Solved! Go to Solution.
It sounds to me like you used the wrong image on the box.
It sounds to me like you used the wrong image on the box.
Thanks for the reply. It was caused by a wrong image. We have since rectified and used only the ESM image.
Corporate Headquarters
6220 America Center Drive
San Jose, CA 95002 USA