Hi All,
We have a ns 7100, but a "CP write error: No space left on device " show when boot up
May it be any idea how to fix?
Regards
Tony
Solved! Go to Solution.
Hi All,
As open case, KB85613 solve the case
Procedure:
1. enter rescure mode
2. load rescure image
3. upgrade IPS as normal
Regards
Tony
Hi All,
Please also find logs as below
Hi @tonyssbear ,
Did you upgrade the Sensor software recently that caused a reboot?
In order to verify the disk space, kindly reach out to the support team because they can log in to the backend of the device and confirm the disk space.
Before reaching out the Support you can try to perform a Power Cycle (remove all power cable(s) - keep device idle for 2-3 minutes - reconnect the cables) and re-validate if the login is successful.
Post power cycle, if the Sensor doesn't go beyond 'Starting application. Please wait for login prompt...', a re-image of the appliance might be required. This again can be confirmed by the Support Team.
Regards,
Faizan
Was my reply helpful?
If you find this post useful, please give it a Kudos! l Also, Please don't forget to select "Accept as a solution" if this reply resolves your query!
Hi All,
As open case, KB85613 solve the case
Procedure:
1. enter rescure mode
2. load rescure image
3. upgrade IPS as normal
Regards
Tony
Corporate Headquarters
6220 America Center Drive
San Jose, CA 95002 USA