I've been placed in a role where I am responsible for supporting a server stack which uses McAfee Firewall Enterprise. I have no experience of using or working with this product so any help or direction will be much appreciated.
The firewall stopped working on a DR site. When trying to access the firewall I could not gain access via the admin console. I then connected the monitor to the firewall directly to see a fatal error message when trying to load the configuration (could also not log in here). As I could not gain access it was suggested to wipe the firewall back to version 8.2.0, patch it back to 8.2.1 then restore the configuration from the live system. I have attempted to do this but as soon as the firewall reboots after restoring the configuration the fatal error message appears again while attempting to load the configuration. I have tried restoring with a number of config back up but this error seems to persist. Its not a corrupt configuration as it is fully working on the live system.
Could someone point me toward a potential solution to this?
Sorry again if this is a bit vague but I have very limited experience with hardware firewalls and networking.
Does the appliance run OK with a basic configuration installed?
It could be a hardware issue, but either way it is probably best that you raise a ticket with McAfee support and get one of their engineers to run through some diagnostics with you.
Once I first patch the firewall to 8.2.1 I can still connect to it yes. It just appears to go wrong during the configuration restore process. I've double checked that the live and DR firewalls are set up correctly and using the same versions, etc. Thanks
Without any data at all I can only guess as to what is going wrong here.
This is what I would do:
Does the firewall boot successfully now?
McAfee Service Portal customers please use your existing username and password to log into the community.