I am trying to scan a very large application server to see if I have the right exclusions implemented, but every time I try to scan the server, profiler gives me the "error" - "no data captured as files and processes were not scanned during data capture" . I have tried with 1 minute to 15 minutes range data capture, and can see the "collecting data bar" is running during capture, but the "error" is the same every time.
The server is a data server 2012R2 with 1.5 TB RAM, and 40 cores. ENS 10.7 september update. Normally I have no issues with profiler, but with this server I can not get a result in profiler. Need advice.
Solved! Go to Solution.
Hello @kimbn
Thank you for reaching the support community.
Have you checked if profiler is running locally with the correct permissions?
If so please open a technical support case and upload a procmon capture during the execution of the tool so we can investigate further.
Hello @kimbn
Thank you for reaching the support community.
Have you checked if profiler is running locally with the correct permissions?
If so please open a technical support case and upload a procmon capture during the execution of the tool so we can investigate further.
The profiler is running with the right permissions - admin.
I will go ahead and open a SR but was just confused about choosing product, but I will open it under ENS then.
Best regads,
Kim Bruun
Corporate Headquarters
6220 America Center Drive
San Jose, CA 95002 USA