cancel
Showing results for 
Search instead for 
Did you mean: 
scoutt
Level 11

Exchange 2010 SP3 and MSME 7.6

Jump to solution

     We just installed SP3 for Exchange 2010 and I read that we need patch 1 and rollup1 and then a hotfix to correct Tranport problems. We have patch 1 and when I went out to get rollup1 it was not there, instead rollup2 was out. I installed rollup2 and then we installed sp3. Now the Exchange Tranport service doesn't start and it complains about

Failed to create agent factory for the agent 'McAfeeTxRoutingAgent' with error 'Failed to create type 'McAfee.E12Agents.McTxAgent.McAfeeTxRoutingAgentFactory' from assembly 'C:

\Program Files (x86)\McAfee\MSME\bin\E2007 Agents\McTxAgentX64.dll' due to error 'type not found'.'. Please verify the corresponding transport agent assembly and dependencies 

with correct version are installed.

Do we have to installed rollup2 after sp3? if so how do I fix this if we can't uninstall rollup2

Message was edited by: scoutt on 8/12/13 5:16:49 PM CDT
0 Kudos
1 Solution

Accepted Solutions
scoutt
Level 11

Re: Exchange 2010 SP3 and MSME 7.6

Jump to solution

The fix is, do not install the rollup / update prior to installing SP3 for Exchange.

0 Kudos
1 Reply
scoutt
Level 11

Re: Exchange 2010 SP3 and MSME 7.6

Jump to solution

The fix is, do not install the rollup / update prior to installing SP3 for Exchange.

0 Kudos