ENS 10.6.1 December Update | Error loading settings in console after configuration push |KB92095

[Former Member]

Hello,

We have installed standalone McAfee ENS on machine. After the installation we upgraded the McAfee Agent and then we push the configuration via ENSconfig tool. But the configuration upload fails

And in the ENS console in Advance settings -> Default Client Update and Source Site for Updates

an error is displaying.

However, after following the steps mentioned in KB92095 error was resolved.

KB92095 

It seems that the issue is still not resolved as per KB article. We are using McAfee ENS December update and McAfee ENS agent 5.6.2.209

[Former Member]

Hello @Former Member 

What if you are trying to uninstall the product and re-install it back.

Does that issue is getting resolved?

If you want to report further, You can connect with the Support Team after opening the Service Portal.

Was my reply helpful?
If you find this post useful, Please give it a Kudos! Also, Please don't forget to select "Accept as a solution" if this reply resolves your query!

[Former Member]

Hi @Former Member 

Thanks for the reply!

We have already tried re-installing and installing again. Even formatted the whole machine for testing but the issue still exists.

Regards,

Saurabh

[Former Member]

Hello @Former Member 

Thanks for your response.

I will request you to please open a service request with support team to check further.

Was my reply helpful?
If you find this post useful, Please give it a Kudos! Also, Please don't forget to select "Accept as a solution" if this reply resolves your query!