OS crashed on one system. and while i m trying to recover data... through wintech facing below problems.
1. in new wintech eepc5+v7 which i made with files copeid from CTO Gone wild.
a. I am able to authenticate and authorize
b. But when i click on A43 file manage manage utiliy. its not opening.
c. Command prompt also do not gives cursor.
Note: B & C works with same wintech CD on other encrpyted machines except this.
Simon: I saw Problem with A43 file manage utility in new Wintech on many machines. not sure why its happening.
2. OLD WIntech XP Based. made with the help of Making rescue CD documents.
a. I am able to autheticate and autorize
b. in A43 file management utility it was showing all data.
c. But when I tried to copy the data after 40-50% data recovery. for other data its givin CRC error.
Check hard disk for read errors. There are utilities to perform full disk scan, regardless od encryption state.
If you get errors, different recovery is required.
Repair? What if unreadible sector cannot be "repaired"?
I use HDTune under WinPE (BartPE) to perform disk surface scanning. If too many blocks are marked red (let say more than 5), disk is sent to clean room recovery.
Doesn't matter. Do it before WinTech disk mount, otherwise additional corruption might occur.
Disk scanning is done at disk sector level, not file system level.