Showing results for 
Search instead for 
Did you mean: 

How to Set Up ELM Redundancy in the McAfee ESM

How to Set Up ELM Redundancy in the McAfee ESM

The McAfee ELM collects, compresses, signs, and stores all of the original events that are sent to the McAfee ESM. The ELM redundancy feature will allow a standby ELM device to be used in the event of a disaster. The feature is actually quite simple to set up. You can easily switch to the standby ELM manually in the event of a system maintenance or failure.

To set up the ELM redundancy, you’ll need an additional ELM device that is not already keyed to your McAfee ESM . Just set up the ELM and configure its network, but don’t add it.

After the new, redundant ELM is on the network, you can click on the existing primary ELM device in the ESM, click on the Properties Icon, and select ELM Redundancy. Here, you can just click on the Enable button


Next, just enter the ip address for the new redundant ELM device.and enter the password to key the device.


After that’s all set up, you’ll need to go to the Storage Pools section and set up the storage pools on the standby tab. Just make sure that you have the same amount of storage for your Active ELM and the Standby Elm. We can click on Add and you can various additional storage, such as direct attached storage, iscsi, SAN, NFS, or CIFS.


You will then want to migrate your Management Database under the ELM Configuration section. Click on the ELM Configuration and select the standby radio button, then click on the Migrate DB Button. Then, select your new Storage Device.


Finally, you will want to use the new storage device for your storage pool. Just go to the Storage Pool section and click Edit with your Storage Pool selected.


Then click edit for the existing Storage Device.


Under your Standby ELM section, select your new storage device and click OK. That will enable the redundant Storage Device.


Great, now that the ELM Redundancy is set up, you can switch between the devices by going to the Properties for the ELM device and choose the ELM Redundancy section. Here, you can click on the Switch ELMs button to switch between the Active ELM and the Standby ELM.


Great, so that’s it. Your ELM is now set up with redundancy and you can switch to it if your active ELM runs into an issue.


Dear All,

How about config ELM if i have 2 ESM and 2 ELM? How ELM back up (redundancy) for another one?



Version history
Revision #:
1 of 1
Last update:
‎02-17-2015 10:59 PM
Updated by: