Showing results for 
Show  only  | Search instead for 
Did you mean: 

First Steps - How to Assign an IP Address to ATD


This document will guide you through the process of connecting your ATD to your network.


I. Setup

1. In order to connect your ATD 3100 to your network, you will need to get console access to give the ATD an IP address. To do that, we need to connect to what is labeled as number 8 in the diagram below.This is the console port, which we can connect to a laptop directly or to a terminal server. In this instance, we are connecting to a terminal server.



2. Below is a table of the connection settings that should be used:

  • Baud rate: 115200
  • Number of Bits: 8
  • Parity: None
  • Stop Bits: 1
  • Control Flow: None



II. Assign IP Address to ATD

1. In this instance, we're using a product called Raritan which allows us to plug multiple devices into our terminal server. The first thing we are going to do is log into the ATD using the ATD admin account: the username is cliadmin; the password is atdadmin.




2. Hitting the question mark "?" on your keyboard will give you a list of commands that are available. One such command is the "set" command, which we will be using today, specifically for the IP address and the gateway.


3. Type in both the IP address and the gateway, which in this case is /16.


4. Next, set the appliance gateway.


5. Before you login to the user interface, set your management port settings to make sure that t hey are configured for the switch you will be using. You can set "mgmtport" to auto, which will more than likely take care of whatever connection speed that you have.


6. If you would like to hard set your connection speed, you can set "mgmtport speed" to "1000 duplex full."


7. At this point, mgmtport is set, and your switch settings match your port settings on your ATD box. We can go ahead and type the command "show," which will display the settings that have been configured.


8. Finally, we can ping the network security manager just to test the network connectivity.




III. Login to ATD

1. Now you can login using the IP address that has just been assigned to ATD. In this instance, it is


2. Click "Proceed anyway"


3. Use the default username and password, which is: username: admin; password: admin.  After logging

     in you'll be prompted to change your password


4. Now you can start configuring ATD to analyze malware.




Version history
Revision #:
1 of 1
Last update:
‎12-20-2018 05:08 AM
Updated by:

Community Help Hub

    New to the forums or need help finding your way around the forums? There's a whole hub of community resources to help you.

  • Find Forum FAQs
  • Learn How to Earn Badges
  • Ask for Help
Go to Community Help

Join the Community

    Thousands of customers use the McAfee Community for peer-to-peer and expert product support. Enjoy these benefits with a free membership:

  • Get helpful solutions from McAfee experts.
  • Stay connected to product conversations that matter to you.
  • Participate in product groups led by McAfee employees.
Join the Community
Join the Community