I'm having problems with Dell computers after DLP installation. After DLP (only Device Control, actually) is installed, I can verify that it is working (correct revision ID, blocking pen drives). Even when I reboot or shutdown there is no problem. After a while (and some reboots/shutdowns) when I try to reboot/shutdown again the system hangs at startup. I can only see the first Dell image prior to BIOS and the loading animation. It will stay that way indefinitely.
This already happened on Dell Computers models 34xx and when it happens the first time, every new reboot will cause the same issue. Booting in safe mode works. When DLP is removed the system startup occurs without any problems.
Windows 10 version 1903 with DLP version 22.214.171.124.
There are no known issues that I am aware of that demonstrates the issues you are seeing in DLP version 126.96.36.199. However, prior to the release of DLP 188.8.131.52, there were a couple of vulnerabilities identified that could cause blue screens to the endpoint. See SB10295 for more details.
According to KB68147, Windows 10 (32-bit and 64-bit) Version 1903 (May 2019 Update) is compatible and supported with DLP 11.2 or later.
Please contact support and open an SR to troubleshoot the issue with more detail.
Was my reply helpful? If you find this post useful, Please give it a Kudos! Also, Please don't forget to select "Accept as a solution" if this reply resolves your query!
I did several tests and a working solution that is working on some notebooks is the installation of DLP 11.2 (reboot) and then DLP 11.3 (reboot), over the previous version.I will continue the tests and any news comment here in the topic.