cancel
Showing results for 
Search instead for 
Did you mean: 
botyusz
Level 7

Wrong number of solidified files after Task-Solidification

Hello,

I'm new on this community, and I need your help/advice!

Unfortunately I did not find the reason, why my system working strange over the internet.

Hopefully somebode can tell me, what happened.

I've installed the McAfee client on the target system, remotly from the ePO server. Than, I deployed the Solidcore Agent (6.2) After the successfully installation, I've used Client Task - SC Enable without Reboot, to access the relevant commands. On the client, in that time the Solidcore, was in update mode, and CLI was locked down.

I sent, the Client Task - Run Command (so) to solidify the system. The command run correctly, but the result is strange. The command output was the following:


Enumerating installed products.
Solidifying volume C:\
00:13:09: Total files scanned 15571, solidified 2

Which means, the task duration was 13:09 min, and only 2 file was whitelisted from 15571.

BUT THIS IS NOT TRUE!

When I listed the solidified files on the client with sadmin -ls, I've got thousands of file. (unfortunately there is no sum.)

Can somebody tell me, why ePO says only 2?

Thanks in advance:

Botond

0 Kudos
3 Replies
neelima
Level 12

Re: Wrong number of solidified files after Task-Solidification

Botond,

Where in ePO did you see this update?

0 Kudos
botyusz
Level 7

Re: Wrong number of solidified files after Task-Solidification

Hi,

we are using ePO 5.1.1. The solidcore version is 6.2.

As you can see, in the client task log shows this result.

error.jpg

have you seen this already?

Thanks,

Botond

0 Kudos
infosecadmin
Level 7

Re: Wrong number of solidified files after Task-Solidification

I believe that your original task to Enable MAC would have created the whitelist and solidified the drive.  The 2nd task to SO would have picked up anything new that was introduced and not part of the original whitelist.

0 Kudos