Wrong number of solidified files after Task-Solidification
I'm new on this community, and I need your help/advice!
Unfortunately I did not find the reason, why my system working strange over the internet.
Hopefully somebode can tell me, what happened.
I've installed the McAfee client on the target system, remotly from the ePO server. Than, I deployed the Solidcore Agent (6.2) After the successfully installation, I've used Client Task - SC Enable without Reboot, to access the relevant commands. On the client, in that time the Solidcore, was in update mode, and CLI was locked down.
I sent, the Client Task - Run Command (so) to solidify the system. The command run correctly, but the result is strange. The command output was the following:
Re: Wrong number of solidified files after Task-Solidification
I believe that your original task to Enable MAC would have created the whitelist and solidified the drive. The 2nd task to SO would have picked up anything new that was introduced and not part of the original whitelist.