Upgrade Application Control 8.2.1.143 to 8.2.1.435

[kblowe]

Do I need to run the re-solidify command after I upgrade Application Control from version 8.2.1.143 to 8.2.1.435 ?  Please let me know.  I may upgrade in Update mode or just leave in Enable mode for the upgrade.  (Windows 10 1809 and Windows Server 2008R2, 2012R2 systems)

Thanks

[chealey]

Typically to upgrade Solidcore you do not need to put Solidcore into a specific mode. You can just upgrade it even in enable mode.

However due to this known issue KB91257, it is advised to re-solidfy after this upgrade. Typically this step is not needed.

[kblowe]

Thanks for quick response.

Is running command    sadmin so  sufficient enough ?

[chealey]

Yeah, that's fine.

[BenEllis · Accepted solution]

You may want to be aware of this 

https://kc.mcafee.com/corporate/index?page=content&id=KB91353

[kblowe]

Thanks. Ok, I reviewed the KB.

This command is a one liner right or is it multiple commands?

[ktankink]

It's five separate commands in the SC:RunCommands client task.

[kblowe]

Run all commands separately back to back.

Or Run commands separately

bu

config set MaplCommLostRestart=0
so

Wait for system to resolidify then run commands below separately

config set MaplCommLostRestart=5
eu

[kblowe]

Hello, are there still issues with 8.2.1.435 with new installations and or upgrades?

According to KB91257 the issues are resolved in 8.2.1.435 along with 8.2.6/8.3 extensions.

Is that the case?

And do I still need to resolidfy after upgrading to 821.435, if I have 8.3 extensions.

[tucker84]

There's a BSOD issue and a memory leak issue with that version of Solidcore. You might want to wait for the next patch which should be out next month.