Solidcore uninstall

[BenEllis]

This is why i sent the link above 2 replies ago.

Task

1. On the McAfee ePO console, select Menu → Systems → System Tree.
2. Perform one of these actions.
   • To apply a client task to a group, select the group in the System Tree and switch to the Assigned Client Tasks tab.
   • To apply a client task to an endpoint, select the endpoint on the Systems page and click Actions → Agent → Modify Tasks on a Single System.
3. Click Actions → New Client Task Assignment to open the Client Task Assignment Builder page.
4. Select Solidcore 8.1.0 → SC: Observe Mode and click Create New Task to open the Client Task Catalog page.
   1. Specify the task name and add any descriptive information.
   2. Select End Observe Mode and choose to place the endpoints in Enabled or Disabled mode.
5. Click Save, then click Next to open the Schedule page.
6. Specify scheduling details, click Next, then click Save.
7. (Optional) Wake up the agent to send your client task to the endpoint immediately.

[Former Member]

Sorry, just realized there is second page for this topic, I tried the solution You offered and it works.

Thanks

[ktankink · Accepted solution]

@Former Member To be clear, you can't use the SC:Disable task if the MACC (McAfee Application and Change Control) client is in Observe mode, nor can you use the "sadmin disable" command locally.

To switch from Observe to Disable mode for the client:

• Run the SC:Observe Mode client task from ePO; set to End Observe Mode and Disable Solidcore client status in the task settings.
• On the local client:
  • Run "sadmin eo -d"
    OR
  • Run "sadmin eo" (which ends Observe and switches to Enable), then "sadmin disable".
• Reboot