cancel
Showing results for 
Search instead for 
Did you mean: 
bob325
Level 7

Solidcore 6.1.3 // Application control 6.1.3 keep changing to observe mode wothout any task assign

Hi  Team,

I have  install  Application  control  6.1.3  but  it  keep  change  to  observe mode after  couples  hours ,  Have  create  a  task  to  end observe mode  ,  then  active  enable  mode.

AC will be  enabled  then  after  couples  hours  goes  back  again  to  observe mode. Please see  below  a  screenshot  of  events.  the  issue  is  reported  on  two  machines  out  of  5.

Thanks  for  your  help.

observe.png

Bob

0 Kudos
2 Replies
amitchopra
Level 9

Re: Solidcore 6.1.3 // Application control 6.1.3 keep changing to observe mode wothout any task assign

Hi Bob,

Can you please confirm if any client task to enter Observe mode is scheduled from ePO

0 Kudos
bob325
Level 7

Re: Solidcore 6.1.3 // Application control 6.1.3 keep changing to observe mode wothout any task assign

Hi  Amit,

Thanks  for  your  reply ,  I haven't  Observer Mode  task  scheduled from ePO.

The  issue  seem  to  be  resolved, I have remove  and  reinstall  Solidcore  on  the machine.

Thanks

Noel

0 Kudos