cancel
Showing results for 
Search instead for 
Did you mean: 
bob325
Level 7
Report Inappropriate Content
Message 1 of 3

Solidcore 6.1.3 // Application control 6.1.3 keep changing to observe mode wothout any task assign

Hi  Team,

I have  install  Application  control  6.1.3  but  it  keep  change  to  observe mode after  couples  hours ,  Have  create  a  task  to  end observe mode  ,  then  active  enable  mode.

AC will be  enabled  then  after  couples  hours  goes  back  again  to  observe mode. Please see  below  a  screenshot  of  events.  the  issue  is  reported  on  two  machines  out  of  5.

Thanks  for  your  help.

observe.png

Bob

2 Replies

Re: Solidcore 6.1.3 // Application control 6.1.3 keep changing to observe mode wothout any task assign

Hi Bob,

Can you please confirm if any client task to enter Observe mode is scheduled from ePO

Highlighted
bob325
Level 7
Report Inappropriate Content
Message 3 of 3

Re: Solidcore 6.1.3 // Application control 6.1.3 keep changing to observe mode wothout any task assign

Hi  Amit,

Thanks  for  your  reply ,  I haven't  Observer Mode  task  scheduled from ePO.

The  issue  seem  to  be  resolved, I have remove  and  reinstall  Solidcore  on  the machine.

Thanks

Noel

Member Rewards
McAfee Community rewards active and helpful members just like you. Click here to take a look at the first community members who received a special reward and were recognized by McAfee leader, Aneel Jaeel, for their participation and trusted knowledge in the community.