Solid Core Activation error - Windows 7 Embedded - Solid Core version 7.0.0-646

[Conrai]

I have some Dynics machines  ( Windows 7 Embedded ) here

They all have Solidcore installed and the disk solidified, but have Solidcore status disabled, and when trying to activate, the following message appeared on the screen:

What could I do to solve this problem?

[AdithyanT]

Hi @Conrai,

Thank you for your post here! May I know the content referred here when you say you try to activate?

Are you using an SC enable task? or are you using sadmin enable command by recovering the local CLI?

Can you try disabling Memory protection feature and then run enable command to see if that makes any difference?

Also, Have you tried a newer version of Solidcore? Does this error come up even if you put them in Observe mode and Update mode as well? Also, Kindly please let me know if you have a Service Request created already for it.

Apologies for too many questions, I am just trying to get a good understanding of the issue here.