cancel
Showing results for 
Search instead for 
Did you mean: 
steve79
Level 7

Lockdown command not working?

I am currently running version 6 of Solidifer. (stand alone)

I have set the sadmin password

when I run the sadmin lockdown command, it work as intended to where to no critical commands work

BUT when I run the sadmin recover it does NOT ask for the password to unlock, it just unlocks without requesting the password and I am back to where I have full access...

Anyone else have this issue?

0 Kudos
1 Reply
bnicho
Level 7

Re: Lockdown command not working?

If you are opening the command prompt with a process that is trusted it will behave like this.   If you start the command prompt from "start > run" for example, then it should demand the password.

Regards,

bnicho

0 Kudos