cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Former Member
Not applicable
Report Inappropriate Content
Message 1 of 3

Getting error "Another command [so] is already running"

I am getting error "Another command [so] is already running"  when i am running "Enable Blocking Mode" or "Begin Initial Observe Mode" to initiate solidification process.

Solidcore client - 8.2.1-435, Solidore extension - 8.2.1.229, Mcafee Agent - 5.6.2.209

I am not sure why am i getting this error, i have always ensured that i am the only one connected to client. Also i always run one task at a time and wait for its completion before running another one, still i have this error.

When i run "Begin Initial Observe Mode" to initiate solidification process , this is the only task running on client trying to solidify the system. I don't understand why is mcafee solidcore trying to run another so command when it is already running an instance of the same for solidification process? 

I start getting this error "Another command [so] is already running" after "Begin Initial Observe Mode" task runs for 30-40 mins and then this error keeps repeating itself

How can i avoid this error?

 

 

 

2 Replies
Pravas
McAfee Employee
McAfee Employee
Report Inappropriate Content
Message 2 of 3

Re: Getting error "Another command [so] is already running"

Hi @Former Member ,

I understand that you're reporting an error with SolidCore Command line being in use.


Do you get this error with any SolidCore commands or specific ?

Also does it helps if you logoff & login or try reboot?

 

Thanks

 

Was my reply helpful?
If you find this post useful, Please give it a Kudos! Also, Please don't forget to select "Accept as a solution" if this reply resolves your query!

ktankink
McAfee Employee
McAfee Employee
Report Inappropriate Content
Message 3 of 3

Re: Getting error "Another command [so] is already running"

Hi @Former Member 

""Another command [so] is already running""

  • This means that a solidification task (either via SC:Enable task, SC:RunCommand task, or local execution of 'sadmin so") is already running on the system.  This is typically ran by the SC:Enable task which should be used to activate the MACC License on the system (if not done during the installation) and start the solidification process.  No other tasks can be ran on the MACC client until the SC:Enable task is finished (solidification can run for a while (usually an hour or more depending on the amount of files to be solidified on the local system hard disks).

 

""Begin Initial Observe Mode" to initiate solidification process"

  • I'm not exactly what this task is (it may be a SC:Enable task with a custom name), but as mentioned before, use the SC:Enable client task to start the solidification process.  This will add the MACC license to the client, put the system into Update or Observe mode (depending on the SC:Enable task config), then start the solidification process.  If the SC:Enable task is ran with Observe mode selected, then the MACC client should already be in Observe mode while solidification is running.

 

You Deserve an Award
Don't forget, when your helpful posts earn a kudos or get accepted as a solution you can unlock perks and badges. Those aren't the only badges, either. How many can you collect? Click here to learn more.

Community Help Hub

    New to the forums or need help finding your way around the forums? There's a whole hub of community resources to help you.

  • Find Forum FAQs
  • Learn How to Earn Badges
  • Ask for Help
Go to Community Help

Join the Community

    Thousands of customers use the McAfee Community for peer-to-peer and expert product support. Enjoy these benefits with a free membership:

  • Get helpful solutions from McAfee experts.
  • Stay connected to product conversations that matter to you.
  • Participate in product groups led by McAfee employees.
Join the Community
Join the Community