Hi, I want to configure network ports on my ATD appliances, but I keep on getting an error "Setting admin status ....." I'm connected via SSH with the cliadmin account to the devices. I can't enable a port, set the ip or gateway.
Make sure that the cable is properly connected to management port.
Also, try to reboot the server and see if this resolves the issue?
I none of the above resolves the issue please share these info:
1 - The commands you typed
2 - output of show command
3 - If possible, a photo of management port in the back of the appliance?
Have you managed to configure eth2 with the same cable and connected to the same switch?
If yes, then get LDT logs by following this article
Once you have the LDT logs raise a new case with McAfee Support and attach the LDT logs.